Print this pagePrint this page

Email this topicEmail this topic

View PDFView PDF

Download EPUBDownload EPUB

terminal (user and privi exec modes)

Sets the length and width of the CLI display window on a terminal
Note

Note

This command and its syntax is common to both the User Executable and Privilege Executable configuration modes.

Supported in the following platforms:

  • Access Points — AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8432, AP8533
  • Wireless Controller — RFS4010
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

terminal [length|width] <0-512>

Parameters

terminal [length|width] <0-512>

length <0-512>

Sets the number of lines displayed on a terminal window

  • <0-512> – Specify a value from 0 - 512.

width <0-512>

Sets the width (the number of characters displayed) of the terminal window

  • <0-512> – Specify a value from 0 - 512.

Example (User Exec Mode)

ap8432-070235>show terminal
Terminal Type: xterm
Length: 24     Width: 80
ap8432-070235>
ap8432-070235>terminal length 80

ap8432-070235>terminal width 100
ap8432-070235>show terminal
Terminal Type: xterm
Length: 80     Width: 100
ap8432-070235>

Example (Privi Exec Mode)

NOC-NX9500#show terminal
Terminal Type: xterm
Length: 24     Width: 80
NOC-NX9500#
NOC-NX9500#terminal length 30
NOC-NX9500#terminal width 100
NOC-NX9500#show terminal
Terminal Type: xterm
Length: 30     Width: 100
NOC-NX9500#

Related Commands

no (user-exec-mode) Resets the width or length of the terminal window
no (priv-exec-mode) Resets the width or length of the terminal window
Published August 2019prev | next
Published August 2019prev | next

Email this topicEmail this topic

Print this pagePrint this page