configure

Enters the configuration mode. Use this command to enter the current device's configuration mode, or enable configuration from the terminal.

Supported in the following platforms:

• Access Points — AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8432, AP8533
• Wireless Controller — RFS4010
• Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

configure {self|terminal}

Parameters

configure {self|terminal}

Examples

nx9500-6C8809#configure self
Enter configuration commands, one per line.  End with CNTL/Z.
nx9500-6C8809(config-device-B4-C7-99-6C-88-09)#

NOC-NX9500#configure terminal
Enter configuration commands, one per line.  End with CNTL/Z.
NOC-NX9500(config)#