cdp
Profile Config Commands
Enables CDP (Cisco Discovery Protocol), a
proprietary data link layer network protocol implemented in Cisco networking equipment
and used to share network information amongst different vendor wireless devices
Supported in the following platforms:
- Access Points — AP7502, AP7522,
AP7532, AP7562, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8432, AP8533
- Wireless Controller — RFS4010
- Service Platforms — NX5500, NX7500,
NX9500, NX9600, VX9000
Syntax
cdp [holdtime <10-1800>|run|timer <5-900>]
Parameters
cdp [holdtime <10-1800>|run|timer <5-900>]
| holdtime
<10-1800> |
Specifies the
holdtime after which transmitted packets are discarded
- <10-1800> – Specify
a value from 10 - 1800 seconds. The default is 180 seconds.
|
| run |
Enables CDP
sniffing and transmit globally. This feature is enabled by default. |
| timer
<5-900> |
Specifies the
interval, in seconds, between successive CDP packet transmission
- <5-900> – Specify a
value from 5 - 900 seconds. The default is 60 seconds.
|
Example
nx9500-6C8809(config profile-default-rfs4000)#cdp run
nx9500-6C8809(config profile-default-rfs4000)#cdp holdtime 1000
nx9500-6C8809(config profile-default-rfs4000)#cdp timer 900
nx9500-6C8809(config-profile-default-rfs4000)#show context
profile rfs4000 default-rfs4000
bridge vlan 1
no edge-vlan
l2-tunnel-broadcast-optimization
.............................................................
qos trust 802.1p
interface pppoe1
use firewall-policy default
cdp holdtime 1000
cdp timer 900
service pm sys-restart
router ospf
nx9500-6C8809(config-profile-default-rfs4000)#
Related Commands
| no |
Disables CDP on this profile |
Print
this page
Email this topic
Feedback
View PDF
Download EPUB