l2tpv3 (user and privi exec modes)

Establishes or brings down a Layer 2 Tunnel Protocol Version 3 (L2TPV3) tunnel

Note

This command and its syntax is common to both the User Executable and Privilege Executable configuration modes.

Supported in the following platforms:

Access Points — AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8432, AP8533
Wireless Controller — RFS4010
Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

l2tpv3 tunnel [<TUNNEL-NAME>|all]

l2tpv3 tunnel <TUNNEL-NAME> [down|session|up]

l2tpv3 tunnel <TUNNEL-NAME> [down|up] {on <DEVICE-NAME>}

l2tpv3 tunnel <TUNNEL-NAME> session <SESSION-NAME> [down|up] {on <DEVICE-NAME>}

l2tpv3 tunnel all [down|up] {on <DEVICE-NAME>}

l2tpv3 tunnel <TUNNEL-NAME> [down|up] {on <DEVICE-NAME>}

l2tpv3 tunnel

Establishes or brings down L2TPV3 tunnels

<TUNNEL-NAME> [down|up]

Specifies the tunnel name to establish or bring down

on <DEVICE-NAME>

Optional. Establishes or brings down a tunnel on a specified device

<DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.

l2tpv3 tunnel <TUNNEL-NAME> session <SESSION-NAME> [down|up] {on <DEVICE-NAME>}

l2tpv3 tunnel

Establishes or brings down L2TPV3 tunnels

<TUNNEL-NAME> [session <SESSION-NAME>] [down|up]

Establishes or brings down a specified session inside an L2TPV3 tunnel

<TUNNEL-NAME> – Specify the tunnel name.
- session <SESSION-NAME> – Identifies a specific session
  - <SESSION-NAME> – Specify the session name.
    - down – Brings down the session identified by the <SESSION-NAME> keyword
    - up – Establishes the session identified by the <SESSION-NAME> keyword

on <DEVICE-NAME>

Optional. Establishes or brings down a tunnel session on a specified device

<DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.

l2tpv3 tunnel all [down|up] {on <DEVICE-NAME>}

l2tpv3 tunnel

Establishes or brings down L2TPV3 tunnel

all [down|up]

Establishes or brings down all L2TPV3 tunnels

on <DEVICE-NAME>

Optional. Establishes or brings down all tunnels on a specified device

<DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.

nx9500-6C8809>l2tpv3 tunnel Tunnel1 session Tunnel1Session1 up on nx9500-6C8809

nx9500-6C8809#l2tpv3 tunnel TestTunnel session TestTunnelSession1 up on rfs4000-6DB5D4

Note

For more information on the L2TPV3 tunnel configuration mode and commands, see L2TPV3-POLICY.

Published August 2019prev | next