ex3500-std-access-list
An
EX3500
standard ACL is a policy-based ACL that contains a set of filter criteria and action that is
applied to traffic originating from a specified source.
The following table summarizes IPv4
EX3500 standard ACL configuration commands:
EX3500-Standard-Access-List-Config Commands
Command |
Description |
deny (ex3500-std acl) |
Creates a deny rule that rejects packets from a specified source or sources.
The source can be a single device or a range of devices within a specified
network. Use this command to also edit an existing deny rule. |
permit (ex3500-std acl) |
Creates a permit rule that allows packets from a specified source or sources.
The source can be a single device or a range of devices within a specified
network. Use this command to also edit an existing permit rule. |
no (ex3500-std acl) |
Removes a deny and/or a permit access rule from this IPv4 EX3500 extended ACL |
|

Note
To implement the
EX3500 standard ACL, apply it directly to a
EX35XX device, or to an
EX35XX profile. For more
information, see
access-group.