This command is used to configure the PIM ECMP (Equal Cost Multi Paths) hash algorithm.
| ipv4 | Specifies the IPv4 address family. |
| ipv6 | Specifies the IPv6 address family. |
| hash | Configure Hash Algorithm for Equal Cost Multipath Routing. |
| source | Hash for route sharing is based on source address only. |
| group | Hash for route sharing is based on group address only. |
| source-group | Hash for route sharing is based on source and group addresses. |
| source-group-nexthop | Hash for route sharing is based on source, group, and next hop addresses (default). |
Source-group-nexthop.
Use this command to modify the hash algorithm used by PIM for path selection.
The following command configures the PIM ECMP hash algorithm based on source-group-nexthop:
configure pim ipv6 iproute sharing hash source-group-nexthop
This command was first available in ExtremeXOS 15.3.2.
This command is available on platforms that support the appropriate license.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB