Partitions 100G and 40G ports into multiple partition speeds.
|
For 40G ports the default partition is 1x40G.
For 100G ports the default partition is 1x100G.
Use this command to partition 100G and 40G ports into multiple partition speeds.
The following example partitions port 6:1 into 4 10G ports:
configure ports 6:1 partition 4x10G Warning: Configuration will be lost on ports 6:1 No configuration changes should be made on these ports until after the next reboot. This command will only take effect after save configuration and either reboot switch or disable and enable slots 6. Are you sure you want to continue? (y/N)
This command was available in ExtremeXOS 12.6.
This command was expanded to include partitioning 100G ports in ExtremeXOS 22.2
Switch Model | Port Bandwidth | Each Physical Port Can Operate as.... |
---|---|---|
X670-G2-48x-4q QSFP+ |
40Gb | One 40Gb port or Four 10Gb ports |
X770 (all models) QSFP+ |
40Gb | One 40Gb port or Four 10Gb ports |
X870 (all models) QSFP28 and QSFP+ |
100Gb | One 100Gb port or Two 50Gb ports or Four 25Gb ports Note: An optional Switch Port Speed License is
required for 100Gb on X870-96x-8c series
switches.
|
40Gb | One 40Gb port or Four 10Gb ports |