Completing the Installation

After installing the SSA and connecting it to the network, access the command line interface (CLI) from your PC or terminal connection as described in the following steps.

Note

Use this procedure only for initial login and for logging in to a device that is not yet configured with administratively-supplied user and password settings.

By default, the SSA is configured with three user login accounts:

ro	Read-Only access
rw	Read-Write access
admin	Super-user access to all modifiable parameters

The default password for all three accounts is set to blank (null). For information on changing these default passwords, refer to the S-, K-, and 7100 Series Configuration Guide.

1. Connect a terminal to the local console port as described in Connecting to a Local Management Console.
   The startup screen displays.

   login: admin
   Password:
   SSA
   Command Line Interface
   Extreme Networks, Inc.
   145 Rio Robles
   San Jose, CA 95134 USA
   Phone:  +1 800 998 2408
   E-mail: support@extremenetworks.com
   WWW:    http://www.extremenetworks.com
   (c) Copyright Extreme Networks, Inc. 2016
   Chassis Serial Number:      xxxxxxxxxxxx
   Chassis Firmware Revision:  xx.xx.xx.xxxxT
   User admin last logged in WED SEP 14 16:12:42 2016
   There have been 0 failed login attempts since then
   SSA(su)->

2. At the login prompt, enter one of the following default user names:
   • ro for Read-Only access
   • rw for Read-Write access
   • admin for Super User access. (This access level allows read-write access to all modifiable parameters, including user accounts.)
3. Press Enter.
4. The Password prompt displays. Leave this string blank and press Enter.
   The device information and SSA prompt appear as shown in step 1.