Connecting to a VT Series Terminal

1. Connect the RJ45 connector at one end of the cable to the COM port on the SSA.
2. Plug the RJ45 connector at the other end of the cable into the RJ45-to-DB25 female adapter.
3. Connect the RJ45-to-DB25 adapter to the port labeled COMM on the VT terminal.
4. Turn on the VT terminal and access the Setup directory.
5. Configure the VT terminal as shown in VT Settings.
   

   VT Settings

   Parameter	Setting
   Mode	7 Bit Control
   Transmit	Transmit = 9600
   Bits Parity	8 Bits, No Parity
   Stop Bit	1 Stop Bit