Find a location that supports the following requirements:
The beam must be able to support the access point in all environmental
conditions.
The beam must be flat.
Beam attachment area is at
least 0.5 in. (12.7mm) wide and as long as the access point's largest
dimension.
Beam mounting surface is at
least 0.040 in. (1.0 mm) thick, but less than 0.650 in. (16.5mm) thick.
About this task
If you are installing the access point in a warehouse or other industrial
environments, then you might have to install the AP on a beam instead of a ceiling.
Procedure
Align the red dot on the access
point with the red dot on the accessory bracket.
Insert the plastic part posts into the access point back recess.
Push the access point onto the
plastic part, and rotate the access point about one-sixth turn clockwise to make
it lock in place.
Note
If you can turn or twist
the access point, it was not locked in place properly. Remove the access
point and attach it again until it locks in place.
Connect the network cable.
Open the top screw as necessary
and place the beam clip onto a beam.
Note
You must
hold the access point when attaching the beam clip.
ACC-BKT-AX-BEAM
accessory bracket
Tighten the beam clip top screw
to a torque of 50 in-lbs.
