Install the Access Point on a Silhouette Ceiling

Before you begin

You need the following items:

AP3000
AH-ACC-BKT-AX-SL bracket

About this task

You can mount the access point to a ceiling grid with 1/8 in. or 1/4 in. bottom opening.

Silhouette is an Armstrong Ceiling Solutions name.

Metal ceiling grid with bottom openings.

Procedure

Remove the ceiling tiles.
Place the bracket on the ceiling rail in such a way that the accessory metal hinges are almost perpendicular to the sides of the ceiling rail with the ceiling rail over the center hole.

Lightly push onto to the ceiling rail and rotate the accessory clockwise until the hinges hook over the edge of the rail and the white tabs click in place.

Note

There are two white tabs in the back of the bracket that holds on to the ceiling rail in place. Use your finger to pull and unhook one side of the white tab if you want to remove the accessory from the ceiling rail.

Gently rotate the bracket counterclockwise and if there is resistance, the other white tab in the back of the accessory must also be released.

Image of the AH-ACC-BKT-AX-SL accessory highlighting the hinges, white tab clips, and printed ceiling grid.


Call out	Description
1	Metal hinges on the AH-ACC-BKT-AX-SL bracket.
2	White tabs on the AH-ACC-BKT-AX-SL bracket.
3	Drawing of 1/8 in. or 1/4 in. ceiling grid, for your reference.

Align the red dot on the back of the access point against the accessory bracket red dot.

Note

The accessory has a circular tip that fits into the circular depression on the back of the access point.

Image of the accessory highlighting the circular tip that fits into the back of the access point.


Call out	Description
1	AH-ACC-BKT-AX-SL bracket circular tip

Press and rotate the access point clockwise until it locks into place on the accessory.
Connect the network cable.
Replace the ceiling tiles.