tacacs server secondary-host
Configures the entry for the secondary TACACS+ server.
Syntax
-
default tacacs server
{A.B.C.D}
-
default tacacs server
{A.B.C.D} port
-
default tacacs server
{A.B.C.D} single-connection
-
default tacacs server
{A.B.C.D} single-connection source source-ip-interface enable
-
default tacacs server
{A.B.C.D} source source-ip-interface enable
-
default tacacs server
{A.B.C.D} timeout
-
no tacacs server
{A.B.C.D}
-
no tacacs server {A.B.C.D}
single-connection
-
no tacacs server {A.B.C.D}
source source-ip-interface enable
-
tacacs server
secondary-host {A.B.C.D}
-
tacacs server
secondary-host {A.B.C.D} key WORD<0-128>
-
tacacs server
secondary-host {A.B.C.D} port <1-65535>
-
tacacs server
secondary-host {A.B.C.D} single-connection
-
tacacs server
secondary-host {A.B.C.D} source {A.B.C.D} source-ip-interface enable
-
tacacs server
secondary-host {A.B.C.D} timeout <10-30>
Command Parameters
- {A.B.C.D}
- Specifies the IP address of the
secondary TACACS+ server.
- key WORD<0-128>
- Configures the secret key to share
with this TACACS+ server. If the key length is zero, that indicates no encryption
is used.
- port <1-65535>
- Configures the TCP port on which
the client establishes a connection to the server. A value of 0 indicates that the
system specified default value is used. The default is 49.
- single-connection
- Specifies if the TCP connection
between the device and the TACACS+ server is a single conection. If you do not
enable the single-connection parameter, the system uses the default connection
type that opens and closes a connection for each communication session.
- source {A.B.C.D}
- Configures the IP address of the
interface to use with this server. If you do not configure an address, the system
uses 0.0.0.0 as the default.
- source-ip-interface enable
- Enables the source address. You
must enable this parameter if you configure a valid source IP address. The default
is disabled.
- timeout <10-30>
- Configures the maximum time, in
seconds, to wait for this TACACS+ server to reply. The default is 10 seconds.
Command Mode
Global Configuration
Usage Guidelines
The source {A.B.C.D}
and source-ip-interface
enable parameters are only supported on VSP 8600
Series.
