show ipv6 nd interface

Syntax

• show ipv6 nd interface gigabitEthernet [{slot/port[/sub-port][-slot/port[/sub-port]][,...]}]

• show ipv6 nd interface mgmtEthernet mgmt

• show ipv6 nd interface vlan [<1-4059>]

• show ipv6 nd interface vrf WORD<1-16>

• show ipv6 nd interface vrfids WORD<0-512>

Command Parameters

gigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If your platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

mgmtEthernet mgmt

Displays the neighbor discovery management interface configuration.

vlan <1-4059>

Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.

vrf WORD<1-16>

Specifies a VRF name. The VRF parameter is optional.

vrfids WORD<0-512>

Specifies a VRF by ID. The VRF parameter is optional.

Default

None

Command Mode

User EXEC

Usage Guidelines

The mgmtethernet mgmt parameter only applies to VSP 8600 Series.