Set Threshold Monitor Options

Run the following command to set the threshold monitor options:

efa inventory device threshold-monitor set

For more information on syntax and command examples, see the ExtremeCloud Orchestrator Command Reference, 3.5.0 .

Example

• The following example sets the threshold-monitor hardware-resources interval and count to 60 and 3 respectively. These values apply to the following types: bfd-session, lif, mac-table, vxlan-tunnel, route, host, nexthop, and ecmp.
  

  efa inventory device threshold-monitor set –-type hardware-resources --ip 10.10.10.153-154 --interval 60 --count 3

• The following example sets a CPU threshold-monitor to trigger an SNMP event when the CPU threshold of 80% is exceeded. Ensure that the threshold must be exceeded three times (retry) with a polling interval of 60 seconds for the event to be triggered. This means that it would take three minutes before the notification is sent.
  

  efa inventory device threshold-monitor set –-type cpu --ip 10.10.10.153-154 –-actions snmp -–high-limit 80 --retry 3

• The following example sets a mac-table threshold-monitor to trigger an SNMP event when either the high-limit threshold of 80% or the low-limit threshold of 50% is exceeded. Events can be generated for the threshold exceeding the 80% (high) or 50% (low) limits.
  

  efa inventory device threshold-monitor set –-type mac-table --fabric fabric1 –-actions snmp -–high-limit 80 -–low-limit 50