Configure a Port Channel

You can configure a port channel for a tenant. Use the efa tenant po configure command to push or remove the pending port channel configuration. The command pushes the pending configuration for a port channel.

About this task

Follow this procedure to configure a port channel.

Procedure

Run the efa tenant po configure command.
efa tenant po configure [ --name | --tenant | --help ]

Example

The following example pushes or removes the pending port channel configuration:

$ efa tenant po show --name ten1po1 --tenant ten1 --detail
=========================================================
Name                : ten1po1
Tenant              : ten1
ID                  : 1
Description         : tenant1po1
Speed               : 10Gbps
MTU                 : 
Negotiation         : active
Min Link Count      : 2
Lacp Timeout        : long
Ports               : 10.20.246.6[0/1-2]
                    : 10.20.246.5[0/1-2]
State               : port-delete-pending
Dev State           : provisioned
App State           : cfg-in-sync

===========================================================

--- Time Elapsed: 111.335777ms ---


$ efa tenant po configure --name ten1po1 --tenant ten1

PortChannel: ten1po1 configured successfully.

--- Time Elapsed: 114.816703ms ---


$ efa tenant po show --name ten1po1 --tenant ten1 --detail
========================================================
Name              : ten1po1
Tenant            : ten1
ID                : 1
Description       : tenant1po1
Speed		: 10Gbps
MTU               : 
Negotiation       : active
Min Link Count    : 2
Lacp Timeout      : long
Ports		: 10.20.246.6[0/1-2]
                  : 10.20.246.5[0/1-2]
State		: po-created
Dev State         : provisioned
App State         : cfg-in-sync

=======================================================

--- Time Elapsed: 120.391994ms ---