Configure VLAN-Based Mirroring in a Multi-Tenant Architecture

efa tenant epg create --name <epg-name> --tenant <tenant-name>

   --switchport --switchport-mode trunk –ctag-range <ctag-range>
   --port <mirror-source-port-list> --po <mirror-source-po-list>

   --pp-mac-acl-in <acl-name> --pp-mac-acl-out <acl-name>
   --pp-ip-acl-in <acl-name> --pp-ip-acl-out <acl-name>

   --np-mac-acl-in <ctag:acl-name> --np-mac-acl-out <ctag:acl-name>
   --np-ip-acl-in <ctag:acl-name> --np-ip-acl-out <ctag:acl-name>

efa tenant service mirror session create –name <session-name> --tenant <tenant-name>

   --source {<device-ip>,<eth | po | vlan>,<if-name>}
   --type {<source-device-ip>,<eth | po | vlan>,<source-if-name>:<port-based | flow-based>}

   --destination {<source-device-ip>,<eth | po | vlan>,<source-if-name> :
               <destination-device-ip>,<eth | po | vlan>,<destination-if-name}
   --destination-type {<source-device-ip>,< eth | po | vlan>,<source-if-name>:<span>}

   --direction {<source-device-ip>,< eth | po | vlan>,<source-if-name> : <tx | rx | both>}


(efa:root)root@node-2:~# efa tenant show
+-------+-------+------+------+------+------+------+---------------------+------------------+
|Name   | Type  | VLAN | L2VNI| L3VNI| VRF  |Enable|        Ports        |  Mirroring Ports |
|       |       | Range| Range| Range| Count|BD    |                     |                  |
+-------+-------+------+------+------+------+------+---------------------+------------------+
|shared |Shared |      |      |      |   0  |false |                     |10.20.246.16[0/31]|
|Tenant |       |      |      |      |      |      |                     |10.20.246.21[0/31]|
|       |       |      |      |      |      |      |                     |10.20.246.22[0/31]|
|       |       |      |      |      |      |      |                     |10.20.246.25[0/31]|
|       |       |      |      |      |      |      |                     |10.20.246.26[0/31]|
+-------+-------+------+------+------+------+------+---------------------+------------------+
| ten1  |private| 11-20|      |      |   10 |false |10.20.246.15[0/1-10] |                  | 
|       |       |      |      |      |      |      |10.20.246.16[0/1-10] |                  |
|       |       |      |      |      |      |      |10.20.246.21[0/1-10] |                  |
|       |       |      |      |      |      |      |10.20.246.22[0/1-10] |                  |
+-------+-------+------+------+------+------+------+---------------------+------------------+
| ten2  |private| 21-30|      |      |   10 |false |10.20.246.15[0/11-20]|                  |
|       |       |      |      |      |      |      |10.20.246.16[0/11-20]|                  |
|       |       |      |      |      |      |      |10.20.246.21[0/11-20]|                  |
|       |       |      |      |      |      |      |10.20.246.22[0/11-20]|                  |
+-------+-------+------+------+------+------+------+---------------------+------------------+


(efa:root)root@node 2:~# efa tenant po show
+--------+-------+-----------+-----+-----------+----------+-------+-------------------+-----------+-------------+-------------+
|  Name  |Tenant |ID | Speed | MTU |Negotiation| Min Link | Lacp  |        Ports      |    State  |  Dev State  |  App State  |
|        |       |   |       |     |           |   Count  |Timeout|                   |           |             |             |
+--------+-------+-----------+-----+-----------+----------+-------+-------------------+-----------+-------------+-------------+
|ten1po1 |ten1   | 2 | 10Gbps|     |   active  |    1     |  long | 10.20.246.15[0/1] | po-created| provisioned | cfg-in-sync |
|        |       |   |       |     |           |          |       | 10.20.246.16[0/1] |           |             |             |
+--------+-------+-----------+-----+-----------+----------+-------+-------------------+-----------+-------------+-------------+
|ten2po1 |ten2   | 3 | 10Gbps|     |   active  |    1     |  long | 10.20.246.15[0/11]| po-created| provisioned | cfg-in-sync |
|        |       |   |       |     |           |          |       | 10.20.246.16[0/11]|           |             |             |
+--------+-------+-----------+-----+-----------+----------+-------+-------------------+-----------+-------------+-------------+
|ten1po2 |ten1   | 2 | 10Gbps|     |   active  |    1     |  long | 10.20.246.21[0/1] | po-created| provisioned | cfg-in-sync |
|        |       |   |       |     |           |          |       | 10.20.246.22[0/1] |           |             |             |
+--------+-------+-----------+-----+-----------+----------+-------+-------------------+-----------+-------------+-------------+
|ten2po2 |ten2   | 3 | 10Gbps|     |   active  |    1     |  long | 10.20.246.21[0/11]| po-created| provisioned | cfg-in-sync |
|        |       |   |       |     |           |          |       | 10.20.246.22[0/11]|           |             |             |
+--------+-------+---+-------+-----+-----------+----------+-------+-------------------+-----------+-------------+-------------+

Example

efa tenant epg create –name ten1epg1 –tenant ten1 --switchport-mode trunk --po ten1po1,ten1po2 --ctag-range 11 --np-mac-acl-in 11:ext-mac-permit-any-mirror-acl --np-mac-acl-out 11:ext-mac-permit-any-mirror-acl efa tenant service mirror session create –name ten1mirrorsession1 --tenant ten1 --source vlan,11 --type vlan,11:flow-based --destination-type vlan,11:span --destination vlan,11:10.20.246.15,eth,0/31 --direction vlan,11:both

efa tenant epg create –name ten2epg1 –tenant ten2 --switchport-mode trunk --po ten2po1,ten2po2 --ctag-range 21 --np-mac-acl-in 21:ext-mac-permit-any-mirror-acl --np-mac-acl-out 21:ext-mac-permit-any-mirror-acl efa tenant service mirror session create –name ten2mirrorsession1 --tenant ten2 --source vlan,21 --type vlan,21:flow-based --destination-type vlan,21:span --destination vlan,21:10.20.246.16,eth,0/31 --direction vlan,21:both