Installing an AC Power Supply
You can install an AC power supply in an
E4G-400 router.

Warning
To prevent an
electrical hazard, make sure that the AC power cord is disconnected from the
power supply before you install the power supply in the router.

Caution
Make sure the AC power supply circuit is
not overloaded. Use proper precautions, such as a circuit breaker, to prevent
overcurrent conditions.
-
On the rear panel of the E4G-400 router, remove
the blank panel from the power supply tray as shown in the following figure.
-
Slide the power supply into the router as shown in
the following figure.
Installing an AC Power Supply
-
Push the power supply in until the latch snaps into place.

Note
If power supplies are not installed in
both power supply bays, be sure to install a panel to cover the unoccupied
bay. The panel is required for maintaining proper system ventilation and EMI
levels.
-
Connect the power cord to the power input connector and
rotate the wire cord retainer over the power cord connector to hold
the connector in place.