Preparing the DC Power Input Cable

1. Strip 0.25 inch (6.4 mm) from the ends of two lengths of #14 AWG copper wire.
2. On the provided connector, identify the positions where you will attach the wires.
   

   Wire Positions in the DC Connector

   DC Power Source	–Connection	+Connection
   –48 VDC	48 RTN	–48 V
   +24 VDC	+24 V	GND

3. Insert each stripped wire into the connector, as shown in the following figure.

   Make sure that no exposed part of the copper wire extends beyond either side of the connector.

   

   Preparing a DC Power Cable

   
4. Tighten each retaining screw to 4.5 pound-inches (0.5 Newton-meters) to fasten the wire in place.