Removing the Power Supply

1. De-energize the DC circuit.
2. Disconnect the DC power cables.
   1. Slide the cover off the terminal block.
   2. Loosen the screws that secure the cable terminals to the terminal block.
   3. Slide the wires out from under the captive washers.
3. Disconnect the ground wire.
   1. Remove the screw that secures the ground wire to the power supply.
   2. Move the wire away from the power supply.
4. Push the latching tab to the left as you pull outward on the handle to disengage the power supply internal connectors
5. Carefully slide the power supply the rest of the way out of the router, as shown in the figures below.
   

   Caution

   Power supplies can become very hot during operation. Wear thermal protective gloves when you remove a power supply from an operating router.

   

   Removing a Summit 300 W DC Power Supply (Model 10934A)

   

   

   Removing a Summit 300 W DC Power Supply (Model 10933)