Configuring IGMP-SSM Mapping

To support PIM-SSM for IGMPv1 and IGMPv2 clients, a PIM-SSM range must be configured, and that range should include all groups to which the clients want access. If IGMPv1 and IGMPv2 clients request group addresses outside the PIM-SSM range, those addresses are ignored by PIM-SSM and forwarded to PIM as (*, G) requests.

To enable IGMP (Internet Group Management Protocol)-SSM mapping, first configure a PIM-SSM range, and then enable IGMP-SSM mapping using the following commands:
configure pim ssm range [default | policy policy-name]

enable igmp ssm-map {vr vr-name}
To configure an IGMP-SSM mapping, use the following command:
configure igmp ssm-map add group_ip [prefix | mask] [source_ip | src_domain_name] {vr vr-name}
To remove a single IGMP-SSM mapping, use the following command:
configure igmp ssm-map delete group_ip [ prefix} | mask] [source_ip | all] vr vr-name }
To remove all IGMP-SSM mappings on a virtual router (VR), use the following command:
unconfigure igmp ssm-map {vr vr-name}
To disable IGMP-SSM mapping on a virtual router, use the following command:
disable igmp ssm-map {vr vr-name}

Published March 2020prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback