Configure Route Reflectors

The configuration for a router reflector topology takes place on the router or routers that serve as route reflectors. Route reflector clients must be configured for BGP (Border Gateway Protocol) participation, but no special configuration is required on route reflector clients to support the route reflector.

To configure a route reflector to treat neighbors or peer group neighbors as route reflector clients, use the following commands:

configure bgp neighbor [remoteaddr | all] [route-reflector-client | no-route-reflector-client]

configure bgp peer-group peer-group-name [route-reflector-client | no-route-reflector-client]
If multiple route reflectors are used in a cluster, you must configure the route reflector clients on each route reflector, and you must configure each route reflector with a common cluster ID using the following command:

configure bgp cluster-id cluster-id

Published March 2020prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback