The traceroute command enables you to trace the path between the switch and a destination endstation.
traceroute {vr vrid} {ipv4 host} {ipv6 host} {ttl number} {from from} {[port port] | icmp}| vr | The name of the virtual router (VR). |
| ipv4/ipv6 | The transport. |
| from | Uses the specified source address in the ICMP (Internet Control Message Protocol) packet. If not specified, the address of the transmitting interface is used. |
| host | The host of the destination endstation. To use the hostname, you must first configure DNS. |
| ttl | Configures the switch to trace the hops until the time-to-live has been exceeded for the switch. |
| port | Uses the specified UDP port number. |
| icmp | Uses ICMP echo messages to trace the routed path. |
Print
this page
Email this topic
Feedback
View PDF
Download EPUB