Creating a test profile

To configure the Y.1731 performance monitoring feature on your Extreme device, perform the follow the task.

Enter the global configuration mode.
```
device# configure terminal
```
Use the protocol cfm command to enter the CFM protocol configuration mode
```
device(config)# protocol cfm
```
Use the y1731 command to enter the Y.1731 configuration mode.
```
device(config-cfm)# y1731
```

Use the test-profile command to create a test profile.

device(config-cfm-y1731)# test-profile mytest-profile

Use the type command to configure the profile type as ETH-DM or ETH-SLM.
```
device(config-cfm-y1731-mytest-profile)# type delay-management
```
```
device(config-cfm-y1731-mytest-profile)# type synthetic-loss-measurement
```
Enter the synthetic-loss-measurement to configure the profile type as ETH-SLM
Use the tx-interval command to configure the transmission interval.
```
device(config-cfm-y1731-mytest-profile)# tx-interval 10
```
Use the measurement-interval command to configure the measurement interval.
```
device(config-cfm-y1731-mytest-profile)# measurement-interval 30
```

Use the start command to configure the start time.

device(config-cfm-y1731-mytest-profile)# start daily 09:00:00

Use the stop command to configure the stop time.

device(config-cfm-y1731-mytest-profile)# stop 17:00:00

Use the cos command to configure the class of service (CoS).
```
device(config-cfm-y1731-mytest-profile)# cos 7
```

Use the threshold command to configure the threshold for the ETH-DM.

device(config-cfm-y1731-mytest-profile)# threshold average 4294967295

Use the tx-frame-count command to configure the tx frame count.
```
device(config-cfm-y1731-mytest-profile)# tx-frame-count 900
```
Use the timeout command to configure the timeout value.
```
device(config-cfm-y1731-mytest-profile)# timeout 3
```