Configuring PE

  1. To enable CFM for VPLS, enter the following command. 
    device(config)# protocol cfm 
device(config-cfm)#
  2. Create a maintenance domain with a specified name and level. 
    device(config-cfm)# domain-name md1 id 1 level 7
device (config-cfm-md-md1)#
  3. Create a maintenance association for the VPLS service. 
    device (config-cfm-md-md1)# ma ma1 id 5 bridge-domain 20 priority 7
device (config-cfm-md-ma-ma1)#
  4. Create an MEP for the VPLS service. 
    device(config-cfm-md-ma-ma1)# mep 101 down vlan 100 ethernet 1/2
device(config-cfm-md-ma-mep-101)#
    Note

    Note

    Follow the same steps to configure PE2 and PE3, to complete the configuration shown in Figure 2. All CFM configuration is same in PE2 and PE3 except the mep-id, which is configured with a different values on PE2 and PE3.
9036676-01 Rev AA