Configuring the Usage Threshold
The system generates an SNMP event after a preset percentage of the
reserved power for any slot or total power for a stand-alone switch is actually used by a
connected PD. This preset percentage is called the usage threshold and is the percentage of
the measured power to the budgeted power for each slot or total power for a stand-alone
switch.
The default value for this usage threshold is 70%. You can configure the
usage threshold to be any integer between 1% and 99%.
-
To configure the threshold percentage of budgeted power
used on a slot or the total power on a stand-alone switch that causes the system to
generate an SNMP event and EMS message, use the following command:
-
To reset the threshold that causes the system to generate
an SNMP event and EMS message per slot to 70% for measured power compared to budgeted
power, use the following command:
-
To display the currently configured usage threshold, use
the following command: