Site-Level AP Actions

Go to either Monitor > Sites or Configure > Sites, select a site, then select Access Points.

Select any or all APs in the Site Access Points list, then select Actions and choose from the following options:

• Assign to Floor — Enter the site floor number to which you want to assign the selected APs.

• Image Upgrade — Select from the list of AP version images and apply to selected APs. If more than one AP is selected, the upgrade image must be common between the selected APs. If not, a message displays indicating that there is no common image. Download appropriate image or select different APs. For information on downloading an upgrade image, see Software Upgrade.

  Minimize service impact. Check this box to upgrade APs without impacting AP service to clients. When this option is enabled, APs upgrade in batches allowing clients to roam to other APs during an AP upgrade.

  

  Note

  Minimize service impact is enabled by default.
  The order for AP upgrade is as follows:

  1. APs without clients.
  2. APs with < 1kB per second traffic via the APs wired port.
  3. APs grouped by channel. APs serving the same channel are upgraded together.
  4. APs serving DFS and Weather channels.

  There is a delay of 180 seconds between upgrading each set of APs. APs serving DFS and Weather channels are upgraded within a 9-minute interval.

• Delete — Remove selected APs from this site.

• Reboot — Restart the selected APs.