Feature Licensing for Universal Hardware

Extreme Networks offers universal hardware products that support more than one Network Operating System (NOS) personality. The universal hardware products share a unified license, which is NOS agnostic.

The Base License, which is included with the purchase of the switch, enables the basic networking capabilities of the device. You can purchase additional licenses separately to enable advanced features on the switch.

Licenses are tied to the switch serial number. After you generate the license through the Extreme Networks Support Portal at https://extremeportal.force.com/ExtrLicenseLanding, you can install the license on the switch manually. You can also use ExtremeCloud IQ to obtain licenses for universal hardware switches.

The following sections detail the different categories of licenses.

Base License

A Base license gives customers the right to use Base software features on the switch.

Licenses for Advanced Features

Licenses enable advanced features not available in the Base License. The following table provides information on the features enabled by each license, if the hardware supports the feature. For information on supported features, see Fabric Engine and VOSS Feature Support Matrix.

License type

Supported features

MACsec License

Note:

Exception: Does not apply to 7520 Series and 7720 Series.

IEEE 802.1AE MACsec

Premier License

  • DvR Controller (5520 Series, 5720 Series, 7520 Series, and 7720 Series)

  • Fabric Connect Layer 3 Virtual Services Networks (VSNs)

  • Extreme Integrated Application Hosting, including Fabric IPsec Gateway (5720 Series, 7520 Series, and 7720 Series)

  • VXLAN Gateway (7520 Series and 7720 Series only)

  • Greater than four OSPF active Interfaces

  • Greater than two BGP peers (does not apply to 7520 Series and 7720 Series)

  • Greater than 16 BGP peers (applies to 7520 Series and 7720 Series only)

10 Gbps Port License

By default, the SFP+ ports on the 5320 Series switches operate at 1 Gbps. To use the ports at full 10 Gbps, you must purchase a 10 Gbps Port License. You can purchase one of two port license types:

You can have a 4-port and an 8-port 10 Gbps license on the same switch simultaneously. To move from one license to another without a loss in connectivity, apply both licenses on the switch before you revoke your original license.

License Types and Part Numbers

The following table lists the license types and the associated part numbers.

License Type

Part Number / Order Code

10 Gbps Port License for the highest four SFP+ ports on the 5320 Series

5320-10GUPG-4X-LIC-P

10 Gbps Port License for all eight SFP+ ports on the 24- and 48-port models of the 5320 Series

5320-10GUPG-8X-LIC-P

MACsec License

5000-PRMR-LIC

Premier License

This license applies to 5320 Series, 5420 Series, 5520 Series, and 5720 Series.

5000-PRMR-LIC

Premier License

This license applies to 7520 Series and 7720 Series.

7000-PRMR-LIC-P