Configure Multi-area SPB Layer 3 Redistribution in Remote Area

About this task

Perform this procedure to configure Multi-area SPB layer 3 redistribution in the remote area.

Procedure

  1. In the navigation pane, expand the Configuration > Fabric folders.
  2. Select MultiArea.
  3. Select the L3 Redist Remote tab.
  4. Select Insert.
  5. In the VrfId field, type the Virtual Router Forwarding ID.
  6. In the Type field, select the layer 3 redistribution type.
  7. Optional: In the RoutePolicy field, type the name of the redistribution policy.
  8. Select Enable.
  9. In the Apply field, select apply.
  10. Select Insert.

L3 Redist Remote Field Descriptions

Use the data in the following table to use the L3 Redist Remote tab.

Name Description

VrfId

Specifies the Virtual Router Forwarding ID.

Type

Specifies the layer 3 redistribution type. The options are:

  • ip-ucast - IPv4 unicast
  • ip-mcast - IPv4 multicast
  • ipv6-ucast - IPv6 unicast

RoutePolicy

Associates a route policy to a specific layer 3 redistribution entry in the remote area.

Enable

Enables layer 3 redistribution in the remote area. The default value is disabled.

Apply

Applies the Multi-area SPB layer 3 redistribution filters in the remote area. The default value is noAction.
9037607-00 Rev AB