Configure OVSDB Managed Interfaces

Note

Exception: only supported on 7520 Series and 7720 Series.

Use the following procedure to configure OVSDB managed interfaces on the switch.

Before you begin

You must enable VXLAN Gateway Full Interworking Mode. For more information, see Enable VXLAN Gateway in Full Interworking Mode.
You must create the required Flex UNI or CVLAN I-SIDs before you configure the OVSDB managed interface.

Procedure

Enter OVSDB Configuration mode:

enable

configure terminal

ovsdb
Configure the OVSDB managed interface:

managed—interface i-sids WORD<1–1024>

Example

The following is an example configuring two I-SIDs as OVSDB management interfaces.

SWITCH:1>enable
SWITCH:1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
SWITCH:1(config)#ovsdb
SWITCH:1(config-ovsdb)#managed-interface i-sids 300
SWITCH:1(config-ovsdb)#managed-interface i-sids 500

What to do next

Configure the OVSDB protocol support for VXLAN Gateway, see Configure OVSDB protocol support for VXLAN Gateway.

Variable definitions

Use the data in the following table to use the managed-interface command.


Variable	Value
i-sids WORD<1–1024>	Specifies the I-SID information to create an interface to manage OVSDB protocol support for VXLAN Gateway. Note: You must create the required Flex UNI or CVLAN I-SIDs before you configure the managed interface I-SID.