Configure OVSDB Replication

Note
Exception: only supported on 7520 Series and 7720 Series.
Use the following procedure to configure OVSDB replication to support vIST.
Before you begin
-
You must enable VXLAN Gateway Full Interworking Mode on the switch.
-
You must configure an OVSDB managed interface on the switch.
-
You must configure and enable OVSDB protocol support for VXLAN Gateway on the switch.
-
You must have at least two NVCs configured to communicate on the managed interface network.
Procedure
Example
SWITCH:1>enable SWITCH:1#configure terminal Enter configuration commands, one per line. End with CNTL/Z. SWITCH:1(config)#ovsdb SWITCH:1(config-ovsdb)#replication peer-ip 192.0.2.3 local-ip 192.0.2.2
Variable definitions
Use the data in the following table to use the replication command.
Variable |
Value |
---|---|
peer-ip <A.B.C.D> |
Specifies the IP address of the secondary controller for OVSDB replication support. |
local-ip <A.B.C.D> |
Specifies the IP address of the primary controller for OVSDB replication support. |