telnet

Opens a Telnet session between two network devices

Note

This command and its syntax is common to both the User Executable and Privilege Executable configuration modes.

Supported in the following platforms:

Access Points — AP410i/e, AP460i/e, AP505i, AP510i/e, AP560i/h, AP7522, AP7532, AP7562, AP7612, AP7632, AP7662, AP8432, AP8533
Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

telnet <IP/HOSTNAME> {<TCP-PORT>} {<INTF-NAME>}

telnet <IP/HOSTNAME> {<TCP-PORT>} {<INTF-NAME>}


<IP/HOSTNAME>	Configures the destination remote system‘s IP (IPv4 or IPv6) address or hostname. The Telnet session is established between the connecting system and the remote system. <IP/HOSTNAME> – Specify the remote system's IPv4 or IPv6 address or hostname.
<TCP-PORT>	Optional. Specify the Transmission Control Protocol (TCP) port number.
<INTF-NAME>	Optional. Specify the interface name for the link local address.

nx9500-6C8809#telnet 10.234.160.36

Entering character mode
Escape character is '^]'.


AP505 release 7.3.0.0-002D
ap505-13403B login: