meshpoint-monitor-interval

Profile Config Commands

Configures the meshpoint monitoring interval. This is the interval, in seconds, at which the meshpoint status is checked.

Supported in the following platforms:

Access Points — AP410i/e, AP460i/e, AP505i, AP510i/e, AP560i/h, AP7522, AP7532, AP7562, AP7612, AP7632, AP7662, AP8432, AP8533
Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

meshpoint-monitor-interval <1-65535>

Parameters

meshpoint-monitor-interval <1-65535>


meshpoint-monitor-interval <1-65535>	Configures the meshpoint monitoring interval in seconds <1-65535> – Specify the interval from 1 - 65535 seconds. The default is 30 seconds.

Example

nx9500-6C8809(config-profile-TestAP8533)#meshpoint-monitor-interval 100

nx9500-6C8809(config-profile-TestAP8533)#show context
profile ap8533 TestAP8533
 bridge vlan 1
  bridging-mode isolated-tunnel
  ip igmp snooping
  ip igmp snooping querier
 meshpoint-monitor-interval 100
 ip default-gateway 172.16.10.4
 --More--
nx9500-6C8809(config-profile-TestAP8533)#

Related Commands


no	Resets the meshpoint monitoring interval to default (30 seconds)