dscp-mapping

Configures IP DSCP (Differentiated Services Code Point) to 802.1p priority mapping for untagged frames

Supported in the following platforms:

Access Points — AP410i/e, AP460i/e, AP505i, AP510i/e, AP560i/h, AP7522, AP7532, AP7562, AP7612, AP7632, AP7662, AP8432, AP8533
Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

dscp-mapping <WORD> priority <0-7>

Parameters

dscp-mapping <word> priority <0-7>


<WORD>	Specifies the DSCP value of a received IP packet. This could be a single value or a list. For example, 10-20, 25, 30-35.
priority <0-7>	Specifies the 802.1p priority to use for a packet if untagged. The priority is set on a scale of 0 - 7. The priority values are: 0 – Best effort 1 – Background 2 – Spare 3 – Excellent effort 4 – Controlled load 5 – Video 6 – Voice 7 – Network control Note: The specified 802.1p priority value is added as a 3-bit IP precedence value in the Type of Service (ToS) field of the IP header used to set the priority. Up to 64 entries are permitted.

Example

nx9500-6C8809(config-profile-default-ap8533)#dscp-mapping 20 priority 7

nx9500-6C8809(config-profile-default-ap8533)#show context
profile ap8533 default-ap8533
 dscp-mapping 20 priority 7
 no autoinstall configuration
 no autoinstall firmware
 crypto isakmp policy default
 crypto ipsec transform-set default esp-aes-256 esp-sha-hmac
 interface me1
 interface ge1
 ip dhcp trust
 qos trust dscp
nx9500-6C8809(config-profile-default-ap8533)#

Related Commands


no	Disables or reverts settings to their default