management-server

Configures a management server with this profile. This command is also applicable to the device configuration context.

Supported in the following platforms:

Access Points — AP410i/e, AP460i/e, AP505i, AP510i/e, AP560i/h, AP7522, AP7532, AP7562, AP7612, AP7632, AP7662, AP8432, AP8533
Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

management-server <HOST-NAME> port <1-65535>

Parameters

management-server <HOST-NAME> port <1-65535>


management-server <HOST-NAME> port <1-65535>	Configures a management server with this profile. Use this command to identify the management server. <HOST-NAME> – Specify the management server‘s host name. port <1-65535> – Specify the port where the management server is reachable. The default setting is port 443. Note: If the adoption-mode, on this profile, is set to ‘cloud‘, ensure that the management-server configuration points to the ExtremeCloud Web address. If the adoption-mode is set to ‘ws-controller‘, provide the ExtremeCloud Appliance controller‘s IP address or hostname as the management server. For information on configuring the adoption-mode, see adoption-mode.

Example

nx9500-6C8809(config-profile-TestAP8533)#management-server nx9500-6C8809 port 300

nx9500-6C8809(config-profile-TestAP8533)#show context include-factory | include management-server
 management-server nx9500-6C8809 port 300
nx9500-6C8809(config-profile-TestAP8533)#

Related Commands


no	Removes the management server configuration