Setting up the Physical Stack

After you have installed the individual switches (see Installing Your 200 Series Switch), follow these steps to create the physical stack.

Connect the switches that will form the stack.
See Connecting the Switches to Form the Stack and Examples of Stacking Configurations.
Connect stacking cables to the switches.
See Connecting a Stacking Cable to a Port.
Connect the switches to your management network.
See Connecting Your Stack to the Management Network.

After setting up and connecting the switches, you can configure software for the stack as if it were a single switch. See Basic Configuration for Your 200 Series Switch for instructions.

Published May 2018prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback