Summit XGM2-2xf Option Card

The Summit XGM2-2xf option card allows you to add one or two 10-gigabit XFP modules to the following switches:

• Summit X350 series switch, running ExtremeXOS 12.1.2 (or later)
• Summit X450a-24t switch, running ExtremeXOS 11.5.0 (or later)
• Summit X450a-24tDC switch, running ExtremeXOS 11.5.0 (or later)
• Summit X450a-24x switch, running ExtremeXOS 11.6.1 (or later)
• Summit X450a-24xDC switch, running ExtremeXOS 11.6.1 (or later)
• Summit X450a-48t switch, running ExtremeXOS 11.5.0 (or later)
• Summit X450e-24p switch, running ExtremeXOS 11.5.0 (or later)
• Summit X450e-48p switch, running ExtremeXOS 11.6.1 (or later)
• Summit X450e-24t switch, running ExtremeXOS 12.5.1 (or later)
• Summit X450e-48t switch, running ExtremeXOS 12.5.1 (or later)

The following figure shows the Summit XGM2-2xf option card.

Summit XGM2-2xf Option Card

The ports on the XGM2-2xf option card can be configured as alternate stacking ports in a SummitStack configuration that uses the SummitStack-V feature. For more information about stacking ExtremeSwitching switches, see Building Stacks.

For current information about compatible XENPAK modules and the minimum required software, refer to the most recent version of the Extreme Hardware/Software Compatibility and Recommendation Matrices.

For information about XENPAK modules, refer to the Extreme Networks Pluggable Transceivers Installation Guide.

Note

Standards-based CX-4 XENPAKs are also recognized by ExtremeXOS. Contact your CX-4 module vendor to obtain them.