Configure up to three ExtremeGuest servers. To
configure an ExtremeGuest server. Take the following steps:
- Go to and select Add.
- Configure the following
parameters:
- IP Address
- Valid IP address of
the ExtremeGuest server.
- Name
- Name of the ExtremeGuest server.
- FQDN
- Fully-qualified
domain name of the ExtremeGuest server.
- Authentication Timeout Duration (Seconds)
- Determines a timeout value, in seconds, for the RADIUS server
connection.
- Authentication Retry Count
- Determines the number of times ExtremeCloud IQ
Controller will
attempt to authenticate an end user.
- Authentication Client UDP Port
- User Datagram Protocol (UDP) port number used for client
authentication. UDP needs only one port for full-duplex, bidirectional traffic.
- Shared Secret
- The password that is
used to validate the connection between ExtremeCloud IQ
Controller and the ExtremeGuest server.
- Mask
- Determines if the Shared Secret or password value is displayed on the user
interface. Enable Mask to display dots in place of the Shared Secret or password value. To
display the password characters, clear the Mask check box.
- Callback User Name
- User ID that Callback
Manager uses to access the ExtremeGuest
server.
- Callback Password
- The password that
Callback Manager uses to access the ExtremeGuest
server. The minimum password length is 6 characters.
- Mask
- Determines if the Shared Secret or password value is displayed on the user
interface. Enable Mask to display dots in place of the Shared Secret or password value. To
display the password characters, clear the Mask check box.
