This tool tests network connectivity between a device acting as a RADIUS
authenticator (RADIUS client) and RADIUS authentication server, which can be an
Extreme Networks RADIUS server, or an external RADIUS authentication or accounting
server.
To test the connectivity between a RADIUS authenticator and a RADIUS server, perform
the following steps:
-
Select the type of RADIUS server
you want to test.
- To test connectivity to an Extreme Networks RADIUS server, choose
Select a
Server (local RADIUS), and then select a RADIUS server
from the drop-down list.
- To test connectivity to an external RADIUS authentication or accounting
server, select Enter a Server (external RADIUS), and enter the IP
address of the server in the field.
-
Select a managed device that is acting as a RADIUS authenticator (client) from
the drop-down list.
This is the device from which
the RADIUS Access-Request or
Accounting-Request message is sent.
-
Select either RADIUS Authentication Server or
RADIUS Accounting Server.
If you select an authentication server, you must also enter supplicant
credentials (a user name or barcode, and a password or PIN) for a valid user
account on the RADIUS authentication server. You can also enter a user name and
password that do not match an account on the RADIUS server.
-
Select
Test.
Results appear under Test Result. A successful test result is
shown below.
RADIUS server is reachable.
Get attributes from RADIUS server: User-Group-ID:0=13; VLAN-ID:1=1;
Session-Timeout=1800
