Before you can enable SD-WAN, you must assign a branch ID to the router, and have one
or two Extreme Networks VGVAs configured as part of a VPN
Service. Then create a Network Policy with Router Settings.
An SD-WAN route group is a list of prioritized WAN ports used as a forwarding action
in a routing policy. Enable SD-WAN in a network policy to configure policies that
make routing decisions based on Layer 7 application service sets, user profiles,
incoming LAN interfaces, or source and destination addresses.
-
Select Enable
SD-WAN.
-
Select Add.
-
Enter a Group Name.
-
Enter an optional description.
-
Set the WAN Priority for the following WAN links on
routers:
- WAN0: The highest prioritized Ethernet link in the
router template.
- WAN1: The second highest prioritized Ethernet link in
the router template.
- USB: The WAN link of a connected USB LTE modem.
-
For Routing Decision Rule, define the following
responses to operational faults for your SD-WAN routing decisions:
- Include
Jitter: Select ON to
have jitter considered for WAN path changes.
- Packet
Loss: Select an aggressive, normal, or moderate response
to packet losses.
- Latency: Select an aggressive, normal, or moderate
response to detected latency.
- Jitter: (Only if Include
Jitter is set to ON):
Select an aggressive, normal, or moderate response to jitter.
Continue configuring the network policy.
