Configuring an LLDP profile to an interface

To configure LLDP interface-level command options, perform the following steps.

1. In privileged EXEC mode, access global configuration mode.
   

   device# configure terminal

2. Access the interface configuration mode.
   

   device(config)# interface Ethernet 0/8

3. Apply an LLDP profile to the interface.
   

   device(conf-if-eth-0/8)# lldp profile network_standard

4. Return to privileged EXEC mode.
   

   device(conf-if-eth-0/8)# end

5. Save the running-config file to the startup-config file.
   

   device# copy running-config startup-config

Example

The following configuration is an example of the previous steps.

device# configure terminal
device(config)# interface Ethernet 0/8
device(conf-if-eth-0/8)# lldp profile network_standard