Installing the SSA Switch on a Flat Surface

For flat surface installation, optionally attach the adhesive rubber feet to the bottom of the SSA switch.

To attach the rubber feet to the bottom of the SSA switch, follow these steps:

Place the SSA switch upside down on a sturdy, flat surface.
Remove the adhesive backing from the four rubber feet.
Adhere the rubber feet to the round, recessed areas on the bottom of the SSA switch.
Turn the SSA switch rightside up.

You can now unpack and install the SSA power supplies. See Unpacking the Power Supplies.

Published December 12, 2016prev | next