Installing the Power Cord Retention Clip Assembly
The SSA switch comes with two optional power cord retention clip assemblies. Power cord retention clips provide added security against the inadvertent removal of the power cord from the power supply AC receptacle.
To install the power cord
retention clip assembly, follow these steps:
-
Holding the strap piece with
the rough side facing away from the power supply, shown by callout 2 of Installing the Power Cord Clip Assembly in the Power Supply, insert the strap
piece into the hole to the right of the power cord receptacle, shown by callout
1.
-
Slide the power cable clamp,
shown by callout 3, onto the strap piece with the tab on the clamp piece facing
out.
-
Insert the power cord in the open clamp.
-
Close the clamp piece.
To open the clamp piece, push
down the clamp release tab, shown by callout 4.
Installing the Power Cord Clip Assembly in the Power Supply
1 = Retention clip receptacle |
3 = Power cable clamp |
2 = Retention clip strap piece, smooth side facing
power supply |
4 = Clamp release tab |