Use the
fields in this window to classify visitors to the site, set
thresholds for device categorization based on zones, and set the
different age outs for devices seen at the site.
To configure the different thresholds:
Select
Settings > System Settings > Thresholds.
The Threshold Configuration and
Management window opens.
Threshold
Configuration and Management window
Select the
Track
Associated devices only switch control to
track associated devices only. All other devices are
ignored.
Set the
following Presence values:
Signal Strength (RSSI) slider
Use the Signal Strength slider to set the
values for device classification as one of
Ignored Devices, Outside
Devices, and Inside
Devices.
A
device is ignored if the signal strength (RSSI) of
the device is below the signal strength value set by
the first slider knob. This is indicated by the
red portion of the Signal Strength (RSSI) slider.
These devices will not be tracked for analysis.
A
device is considered as Inside if
the signal strength (RSSI) of the device is above
the signal strength value set by the second slider
knob. This is indicated by the green portion of the
Signal Strength (RSSI)
slider.
A
device with a signal strength reading between the
two knobs of the Signal Strength
(RSSI) slider is considered as
Outside. This is indicated by
the orange portion of the Signal Strength
(RSSI) slider.
Dwell Time slider
Use the Dwell
Time slider to set the values for device
classification as one of Outside,
Inside Bounce, or Inside
Engaged.
A
device is classified as Outside
if the device is seen in the site for a duration
that is less the duration set by the first slider
knob. This threshold is indicated by the orange portion
of the Dwell Time
slider.
A device is classified as Inside
Engaged if the device is seen in the
site for a duration greater than the duration set by
the second slider knob. This threshold is indicated
by the dark green portion of the Dwell
Time slider.
A device that is seen at the site for a duration
between the times indicated by the two knobs of the
Dwell Time slider is
considered as Inside Bounced.
This duration is indicated by the light green
portion of the Dwell Time slider.
Presence Configuration Graph
Use the graph located to the right of the Signal Strength (RSSI) and Dwell
Time sliders to get a visual
representation of the values used for device
classification.
Set the
following Zone classification values.
Zone Threshold (RSSI) slider
Use the Zone
Threshold (RSSI) slider to set the
threshold RSSI value above which a device is classified
into a category.
Set the
following Age
Out timeout values.
Zone Age Out slider
Use the Zone Age
Out slider to set the zone or category age out value. This
slider sets the time (in minutes) after which, if a visitor's location
information is not received from the ExtremeLocation Essentials service, the visitor is considered to
have left the category or region.
Site Age Out slider
Use the Site Age
Out slider to set the age out value. This slider sets the
time (in minutes) after which, if a visitor has not been seen by any sensor
in a site, the visitor is considered to have left the site.
Select
Save to save the changes made to the
Threshold parameters.
Select the Reset button to
revert the changes made to the threshold parameters.
