Push the Device-Level Configuration to the Device

Perform necessary configuration changes at the device level. After you save these changes, an exclamation mark appears in the device Status column, indicating that the device configuration is out of sync with the network policy.

Use this task to push configuration changes made at the device level to the selected devices, and replace the exclamation marks with green checks.

  1. Go to Manage > Devices and select the devices to update.

    Alternately, got to Manage > Devices > , and select the host_name for a device. On the Configure page, select Update. Proceed to step 3.

  2. Select Update Devices.
  3. Select Delta Configuration Update.
  4. Select Perform Update.

    To avoid an unnecessary system reboot, select Delta Configuration Update. ExtremeCloud IQ attempts to update only the configuration deltas. If a full update is required, the system prompts you to select Complete Configuration Update. Examples of CLI commands that require a full configuration update are: system antenna-type and system environment.

    The status icon changes from an exclamation mark to a green check.
  5. For Universal switches, if you receive an out-of-sync error, hover over the message and review the details to reveal where the local configuration is out of sync.
    1. Match the out-of-sync local configuration within the network policy, switch template, or device level configuration and perform an update device again.
    2. If Step a is not successful, select Perform delta configuration update and resolve local device configuration which is out of sync with ExtremeCloud IQ.
      Note

      Note

      This option requires a minimum version of Switch Engine 32.3 or Fabric Engine 8.9 installed on the Universal switches.