From the Setting Up Your Local Network dialog, you can enter
device serial numbers manually:
-
Select Enter
Manually. Then, enter up to 10 device serial numbers separated
by commas. The devices must all be the same model number.
-
Select the Device OS. For
example, WiNG.
-
Optionally, select Enhanced
Discovery.
Select this option to define up to two specific controller IP addresses that
the selected APs will register with for local service. Provide the IP
address for the controllers. You have the option of defining a primary and
secondary controller.
Note
Enhanced
Discovery is supported on AP3000. It requires ExtremeCloud
IQ version 23.6.1 or greater.
-
Select Onboard
Devices.
-
Select Finish.
The APs display on the ExtremeCloud IQ Device List with the status Onboarded. New APs
display the generic HOSTNAME
because they are not yet registered with ExtremeCloud IQ. The AP Hostname automatically updates after the AP is powered on and
connected into ExtremeCloud IQ.
