Displays link-fault-signaling information.
Exec mode
This command is available only to users with the admin role.
This command is not allowed on management interface.
The following example shows how to configure link-fault-signaling on a device.
device(config)# int e 1/1-16,2/1-16 device(config-if-eth-1/1-16,2/1-16)# no link-fault-signaling devicedevice(config-if-eth-1/1-16,2/1-16)#
The following example shows link-fault-signaling information.
device# show link-fault-signaling
Port Link-Fault
========== ===============
Eth 1/1 OFF
Eth 1/2 ON
Eth 1/3 ON
Eth 1/4 ON
Eth 1/5 ON
Eth 1/6 ON
Eth 1/7 ON