base command | last

Displays only the specified number of last lines from the base command output.

Syntax

base command | last NUMBER

base command: Specifies the base command for filtering the output.
last NUMBER: Specifies the number of last lines from the base command output for displaying.

Filter mode

The "|" symbol in this command does not act as a separator, but instead provides access to the filter command.

The following example displays last four lines of the base command output.

device# ngnpb# show running-config | last 4 

interface management 0 
  ip address dhcp 
  no ipv6 address dhcp 
  no shutdown