base command | exclude

Hides the base command output lines that match the specific token or expression.

Syntax

base command | exclude REGEX

Parameters

base command: Specifies the base command for filtering the output.
exclude REGEX: Specifies the token or expression to match for hiding the base command output lines.

Modes

Filter mode

Usage Guidelines

The "|" symbol in this command does not act as a separator, but instead provides access to the filter command.

Examples

The following example hides the base command output lines that match the expression.

device# show running-config | exclude "ethernet 0" | exclude shutdown 

ntp enable 
ntp server 1.in.pool.ntp.org 
ntp server 2.2.2.2 
ntp server 2.1.1.1 
ntp server 3.2.2.2 
ntp server 3.2.2.1 
interface management 0 
  ip address dhcp 
  no ipv6 address dhcp