Configures the specified slot for a line card of a given type.
Config mode
This command is available only to users with the admin role.
Run this command before physically inserting the line card in the slot.
If the configured line card type does not match the inserted line card type, the card goes into the faulty state.
If the line card is in the faulty state, reconfigure the slot before powering it on.
Power off the line card before removing the slot configuration.
The [no] form of the command removes the slot configuration and powers off the line card.
The following examples show how to configure a slot for the line card and verify the configuration:
device# configure t device(config)# linecard 1 LC16x100G device(config)# no linecard device# show running-config linecard 1 LC16x100G linecard 2 LC4x400G