Attach the Access Point to a Pole Using the KT-147407-02 Bracket Parts and the KT-150173-01 Extension Arm

Before you begin

You can attach the access point to a pole using all the parts of the KT-147407-02 bracket and the KT-150173-01 extension arm.

The following hardware is required:
  • KT-147407-02 flat part
  • KT-147407-02 1-axis tilt part
  • KT-147407-02 pole part
  • KT-150173-01 extension arm
  • Six M6 hex-head screws
  • Four hex-head M12 stainless-steel screws and nuts
  • Two 0.5 in. (12.7 mm) wide stainless-steel cable clamps
  • Access point

About this task

To install the access point on a pole:

Procedure

  1. Attach the KT-147407-02 flat part to the access point.
    For instructions on how to attach the bracket parts, see Install the Access Point to a Flat Surface Using KT-147407-02 Flat Part and 1-Axis Tilt Part.
  2. Align the circular holes on one end of the KT-150173-01 extension arm against the large holes on the 1-axis tilt part.
    Click to expand in new window
    Circular holes on the KT-150173-01 extension arm
    Image of the KT-150173-01 extension arm with circular holes
    Callout Description
    1 Circular holes on the KT-150173-01 extension arm that is used to attach to the KT-147407-02 1-axis tilt part, to attach to the wall, and to KT-147407-02 pole part.
  3. Attach the KT-150173-01 extension arm to the 1-axis tilt part by using two hex-head M12 stainless-steel screws and two hex-head M12 stainless-steel nuts.
  4. Attach the KT-147407-02 pole part to the other end of the KT-150173-01 extension arm using two M12 screws and M12 hex-nuts.
  5. Insert the 0.5 in. (12.7 mm) wide stainless-steel cable clamps through the long slots on the sides of the KT-147407-02 pole part.
  6. Position and insert the ends of the cable clamps around the pole.
  7. Tighten the clamp screws to a torque of 11 in-lbs.
9036418-03 Rev AA